EN 1501-5:2011

Refuse collection vehicles - General requirements and safety requirements - Part 5: Lifting devices for refuse collection vehicles

Publication date:   Dec 16, 2011

General information

99.60 Withdrawal effective   Mar 31, 2021

CEN

CEN/TC 183 Waste management

European Norm

43.160   Special purpose vehicles

Buying

  Withdrawn

PDF - €99.70

  English   Bulgarian  



Buy

Scope

This European Standard deals with all significant hazards, hazardous situations and events relevant to lifting devices used for the emptying of designated waste containers into RCVs and their fitting onto the RCVs when they are used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer throughout their foreseeable lifetime as defined in Clause 4.
This European Standard is applicable to the design and construction of the waste container lifting devices and the mounting of other lifting devices so as to ensure that they are fitted for their function and can be operated, adjusted and maintained during their entire lifetime. It is not applicable to the end of life of the lifting devices.
This European Standard describes and gives the safety requirements of the lifting devices for emptying waste containers and their interfaces with the corresponding parts of the RCVs and shall be used in conjunction with Parts 1, 2 and 3 of EN 1501 for the rear, side and front loaded RCVs. It refers to EN 1501-4 for the noise test code.
This European standard is not applicable to:
- operation in severe conditions e.g. extreme environmental conditions such as:
- temperatures below - 25° C and above + 40°C;
- tropical environment;
- wind velocity in excess of 75 km/h;
- contaminating environment;
- corrosive environment;
- operation in potentially explosive atmospheres;
- lifting and transportation of persons;
- emptying waste containers other than those manufactured according to EN 840, EN 12574, EN 13071, and those described as paladin, diamond, skip containers;
- loading bulky waste by means of platform or forks;
- handling of loads the nature of which could lead to dangerous situations (e.g. hot wastes, acids and bases, radioactive materials, contaminated waste, especially fragile loads, explosives);
- operation on ships;
- fitting and operation on stationary compactors.
This European Standard is not applicable to machinery which is manufactured before the date of its publication by CEN.

Related legislation

Legislation related to this standard

98/37/EC

Machinery

2006/42/EC

Directive 2006/42/EC of the European Parliament and of the Council of 17 May 2006 on machinery, and amending Directive 95/16/EC (recast)

Harmonized/Supporting

Life cycle

PREVIOUSLY

WITHDRAWN
EN 1501-1:1998+A2:2009

NOW

WITHDRAWN
EN 1501-5:2011
99.60 Withdrawal effective
Mar 31, 2021

REVISED BY

PUBLISHED
EN 1501-5:2021