prEN 50483-6

EN 50483-6: Test requirements for low voltage aerial bundled cable accessories - Part 6: Environmental testing prEN 50483-6

General information

10.00 Proposal for new project registered   Apr 9, 2024

CENELEC

CLC/TC 20 Electric cables

European Norm

Scope

EN 50483 series applies to overhead line fittings for tensioning, supporting and connecting aerial bundled cables (ABC) of rated voltage U0/U (Um): 0,6/1 (1,2) kV.
The objective is to provide a method of testing the suitability of accessories when used under normal operating conditions with low voltage aerial bundled cables complying with HD 626 or other relevant standards.
This Part 6 defines the environmental tests in particular the climatic and corrosion ageing tests. The objective of these tests is to predict the behaviour of ABC accessories when subjected to sun radiation, to weather conditions (humidity, spraying water, heat, cold) and pollution. EN 50483-1, EN 50483-2, EN 50483-3 and EN 50483-4 specify which type tests included in this part of the standard are needed.
Climate differs across Europe and in order to meet the differing geographic climatic conditions it is necessary to provide a range of tests to meet these variations. A range of optional, additional tests is provided to meet the varying climatic needs and these should be agreed between the customer and the manufacturer and/or the supplier (see Annex C).
NOTE This European Standard does not invalidate existing approvals of products achieved on the basis of national standards and specifications and/or the demonstration of satisfactory service performance. However, products approved according to such national standards or specifications cannot directly claim approval to this European Standard. It may be possible, subject to agreement between the customer and the manufacturer and/or the supplier, and/or the relevant conformity assessment body, to demonstrate that conformity to the earlier standard can be used to claim conformity to this standard, provided an assessment is made of any additional type testing that may need to be carried out. Any such additional testing that is part of a sequence of testing cannot be done separately.

Life cycle

PREVIOUSLY

PUBLISHED
EN 50483-6:2009

NOW

IN_DEVELOPMENT
prEN 50483-6
10.00 Proposal for new project registered
Apr 9, 2024