prEN 1846-3 rev

Firefighting and rescue service vehicles - Part 3: Permanently installed equipment - Safety and performance

General information

10.99 New project approved   Oct 1, 2024

CEN

CEN/TC 192 Fire and Rescue Service Equipment

European Norm

Scope

1.1 This document specifies the minimum requirements for safety and performance of some
optional specific permanently installed equipment on firefighting and rescue service vehicles,
operated by trained persons, as designated in EN 1846­1 and specified in EN 1846­2.
NOTE 1 Categories and mass classes of the firefighting and rescue service vehicles are
given in EN 1846­1.
NOTE 2 Vehicle means terrestrial vehicles which can also drive on rails and amphibious
vehicles.
The permanently installed equipment covered by this document is given below:
— water installation;
— additive installation;
— monitor;
— equipment gantries;
— demountable systems.
This document applies also to the use of wireless control systems.
For the purposes of this document, the normal ambient temperature range is ­ 15 °C to + 40 °C.
1.2 This document does not apply to the following types of equipment:
— all control systems outside of the cabin related to hook arm system;
— provisions for non­firefighting removable equipment driven by PTO.
1.3 This document applies to the technical requirements to minimise the hazards listed in Clause
4 which can arise during operational use, routine checking and maintenance of firefighting and
rescue service vehicles.
It does not cover the hazards generated by:
— non­permanently installed equipment i.e. portable equipment carried on the vehicle;
— use in potentially explosive atmospheres;
— commissioning and decommissioning;
— noise (as permanently installed equipment cannot be operated separately from the
vehicle, this hazard is covered in Part 2);
— electromagnetic compatibility;
— cyber security;
— cyber safety.
Additional measures not dealt with in this document can be necessary for specific use (e.g. fire
in natural environment, flooding, etc.).
1.4 This document is not applicable to the equipment which is manufactured before its date of
publication by CEN.

Related legislation

Legislation related to this standard

2023/1230

Life cycle

PREVIOUSLY

PUBLISHED
EN 1846-3:2013

NOW

IN_DEVELOPMENT
prEN 1846-3 rev
10.99 New project approved
Oct 1, 2024