This document specifies requirements and tests for the construction, performance, safety and production of battery powered class 1,5 Capillary Thermal-Mass Flow sensor gas meters (hereinafter referred to as meter(s)). This applies to meters having co-axial single pipe, or two pipe connections, that are used to measure volumes of fuel gases of the 2nd and/or 3rd family, as given in EN 437:2021, and non-conventional gases, including up to 20% hydrogen/gas blends and 100% hydrogen.
In general, the term “thermal mass flow meters” applies to a flow-measuring device using heat transfer to measure and indicate gas flowrate, as defined in ISO 14511.
NOTE 1 Although the word “mass” is present in the definition of the measurement principle, gas meters covered by this document provide measurement of gas at base conditions of temperature and pressure.
These meters have a maximum working pressures not exceeding 0,5 bar and a maximum flowrate not exceeding 160 m3⋅h−1 over a minimum ambient temperature range of −10 °C to +40 °C and a gas temperature range as specified by the manufacturer with a minimum range of 40 °C.
Legislation related to this standard
Directive 2014/32/EU of the European Parliament and of the Council of 26 February 2014 on the harmonisation of the laws of the Member States relating to the making available on the market of measuring instruments
PUBLISHED
EN 17526:2021
IN_DEVELOPMENT
prEN 17526 rev
00.60
Close of review
Jun 30, 2023
