10.99 New project approved May 17, 2024
CEN
CEN/TC 155 Plastics piping systems and ducting systems
Technical Specification
This document gives guidance and requirements for the assessment of conformity of materials, products, joints and assemblies in accordance with the applicable part(s) of EN 13476 intended to be included in the manufacturer’s quality plan as part of the quality management system and for the establishment of certification procedures.
NOTE 1 A test matrix provides an overview of the testing scheme in Annex A, Table A.1.
NOTE 2 If certification is involved, the certification body operating in accordance with EN ISO/IEC 17065[1] and EN ISO/IEC 17020[2] is considered to be competent.
In conjunction with prEN 13476 1, prEN 13476 2 and prEN 13476 3 this document is applicable to Plastics piping systems for non-pressure underground drains and sewers — Structural-wall piping systems of unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP) and polyethylene (PE):
— for non-pressure underground drains and sewers outside the building structure (application area code “U”) reflected in the marking of products by “U”, and
for non-pressure underground drains and sewers for both buried in ground within the building structure (application area code “D” and outside the building structure (application area code “U”) reflected in the marking of products by “UD”..
PUBLISHED
CEN/TS 13476-4:2019
IN_DEVELOPMENT
prCEN/TS 13476-4 rev
10.99
New project approved
May 17, 2024