Menu

0

ISO 11992-1:2019

Road vehicles — Interchange of digital information on electrical connections between towing and towed vehicles — Part 1: Physical and data-link layers

Publication date:   May 2, 2019

General information

90.60 Close of review   Sep 3, 2024

ISO

ISO/TC 22/SC 31 Data communication

International Standard

43.040.15   Car informatics. On board computer systems

Buying

  Published

PDF - €156.09

  English  



Buy

Scope

This document describes the data link layer (DLL) and physical layer (PHY) for the two CAN-based network interfaces specified in the 11992-series.
The DLL sub-clauses are composed of:
— DLL protocol entity requirements;
— DLL device interface requirements; and
— DLL network system requirements.
Normally, the physical signalling sub-layer is implemented in the CAN protocol controller. The physical medium attachment sub-layer is normally implemented in the CAN transceiver or the System Base Chip (SBC). Optionally, it can comprise also additional protection circuitry. The media-dependent sub-layer comprises the connectors and the cabling.
The physical signalling (PS) sub-clauses are composed of:
— PS entity requirements;
— PS device interface requirements; and
— PS network system requirements.
The physical medium attachment (PMA) sub-clauses are composed of:
— PMA protocol entity requirements; and
— PMA device interface requirements.
The physical medium dependent (PMD) sub-clauses are composed of:
— PMD entity requirements;
— PMD device interface requirements; and
— PMD network system requirements.

Life cycle

PREVIOUSLY

WITHDRAWN
ISO 11992-1:2003

NOW

PUBLISHED
ISO 11992-1:2019
90.60 Close of review
Sep 3, 2024