EN 848-2:2007

Safety of woodworking machines - One side moulding machines with rotating tool - Part 2: Single spindle hand fed/integrated fed routing machines

Publication date:   Oct 31, 2008

Scope

This document deals with the significant hazards, hazardous situations and events as listed in Clause 4 which are relevant to stationary and displaceable single spindle hand fed/integrated fed routing machines with fixed head but allowing only movement along the axis of the tool during machining hereinafter referred to as "machines" designed to cut solid wood, chip board, fibreboard, plywood and also these materials if they are covered with plastic laminate, edgings or veneer when they are used as intended and under the conditions foreseen by the manufacturer.
NOTE 1 For the definition of stationary and displaceable machine see 3.2.17 and 3.2.18.
This document does not apply to:
a) inverted pin routers and radial arm routers (machines where the work piece is fixed and the tool head is manually moved);
b) NC boring machines and NC routing machines;
NOTE 2 NC boring machines and NC routing machines are dealt with in prEN 848-3:2006.
c) hand-held routers or any adaptation permitting their use in a different mode, e.g. bench mounting;
NOTE 3 Hand-held motor-operated electric tools are dealt with in EN 60745-1:2003 together with EN 60745-2-17:2003.
d) routing machines set up on a bench or a table similar to a bench, which are intended to carry out work in a stationary position, capable of being lifted by one person by hand. The bench can also be an integrated part of the machine if it consists of hinged legs which can be extended down..
NOTE 4 Transportable motor-operated electric tools are dealt with in EN 61029-1:2000 together with
EN 61029-2-8:2003.
This document is not applicable to single spindle hand fed/integrated fed routing machines which are manufactured before the date of its publication as EN.

Related legislation

Legislation related to this standard