EN 116:2015

Diesel and domestic heating fuels - Determination of cold filter plugging point - Stepwise cooling bath method EN 116:2015

Publication date:   Nov 16, 2015

General information

90.93 Standard confirmed   Apr 23, 2021


CEN/TC 19 Gaseous and liquid fuels, lubricants and related products of petroleum, synthetic and biological origin.

European Norm

75.160.20   Liquid fuels



Language in which you want to receive the document.


This European Standard specifies a method for the determination of the cold filter plugging point (CFPP) of diesel and domestic heating fuels (see 3.1) using automated test equipment. Manual test equipment may be used, but for referee purposes only automated test equipment is allowed.
This European Standard is applicable to fatty-acid methyl esters (FAME) and to distillate fuels as well as paraffinic diesel fuels, including those containing FAME, flow-improvers or other additives, intended for use in diesel engines and domestic heating installations.
The results obtained from the method specified in this European Standard are suitable for estimating the lowest temperature at which a fuel will give trouble-free flow in the fuel system.
NOTE In the case of diesel fuels the results are usually close to the temperature of failure in service except when the fuel system contains, for example, a paper filter installed in a location exposed to the weather or if the filter plugging temperature is more than 12 °C below the cloud point of the fuel. Domestic heating installations are usually less critical and often operate satisfactorily at temperatures somewhat lower than those indicated by the test results.
The difference in results obtained from the sample "as received" and after heat treatment at 45°C for 30 min may be used to investigate complaints of unsatisfactory performance under low temperature conditions.
WARNING - The use of this standard may involve hazardous materials, operations and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Life cycle


EN 116:1997

EN 116:1997/AC:1999


EN 116:2015
90.93 Standard confirmed
Apr 23, 2021