EN 10028-5:2009

Flat products made of steels for pressure purposes - Part 5: Weldable fine grain steels, thermomechanically rolled EN 10028-5:2009

Publication date:   Oct 30, 2009

Scope

This European Standard specifies the requirements for flat products for pressure equipments made of
thermomechanically rolled steels as specified in Table 1.
The steels are not suitable for hot forming.
NOTE 1 At the time of publication of this European Standard, no sufficient data for the standardization of the elevated
temperature properties of these steels was available. If their use at such temperatures is intended the conditions for this should
be specially agreed between the interested parties.
The requirements of EN 10028-1 also apply.
NOTE 2 Once this European Standard is published in the EU Official Journal (OJEU) under Directive 97/23/EC, presumption of
conformity to the Essential Safety Requirements (ESRs) of Directive 97/23/EC is limited to technical data of materials in this
European Standard (Part 1 and this Part 5 of the series) and does not presume adequacy of the material to a specific item of
equipment. Consequently, the assessment of the technical data stated in this material standard against the design requirements
of this specific item of equipment to verify that the ESRs of Directive 97/23/EC are satisfied, needs to be done.

Related legislation

Legislation related to this standard