EN 12566-3:2005/prA1

Small wastewater treatment systems for up to 50 PT - Part 3: Packaged and/or site assembled domestic wastewater treatment plants

General information

50.60 Close of voting. Proof returned by secretariat   Nov 14, 2008

CEN

CEN/TC 165 Waste water engineering

European Norm

13.060.30   Sewage water

Scope

This European Standard specifies requirements, test methods, the marking and evaluation of conformity for packaged and/or site assembled domestic wastewater treatment plants (including guest houses and businesses) used for populations up to 50 inhabitants. Small wastewater treatment plants according to this European Standard are used for the treatment of raw domestic wastewater.
It covers plants with tanks made of concrete, steel, PVC-U, Polyethylene (PE), Polypropylene (PP) and Glass Reinforced Polyester (GRP-UP). The test methods specified in this European Standard establish the performance of the plant, needed to verify its suitability for the end use (see 3.1). This European Standard applies for small wastewater treatment plants for use buried in the ground where no vehicle loads are applied to the product. This European Standard applies to plants where all prefabricated components are factory or site-assembled by one manufacturer and which are tested as a whole.
NOTE 1 In some countries, domestic wastewater treatment plants are followed by other systems to conform to national regulations.
NOTE 2 In some countries, domestic waste water treatment plants are followed by other systems to conform to national regulations.

Related legislation

Legislation related to this standard

89/106/EEC

Construction products

305/2011

Regulation (eu) No 305/2011 of the European Parliament and of the Council of 9 march 2011 laying down harmonised conditions for the marketing of construction products and repealing council directive 89/106/eec

Life cycle

PREVIOUSLY

Amends
EN 12566-3:2005

NOW

IN_DEVELOPMENT
EN 12566-3:2005/prA1
50.60 Close of voting. Proof returned by secretariat
Nov 14, 2008