Use the form below to find particular standards or projects. Enter your criteria for searching (single or in combination) in the fields below and press the button “Search”. You can also search using the Advance Search facility.
Plastics — Methods of exposure to laboratory light sources — Part 3: Fluorescent UV lamps
40.99 Full report circulated: DIS approved for registration as FDIS
Plastics — Methods of exposure to laboratory light sources — Part 4: Open-flame carbon-arc lamps
40.99 Full report circulated: DIS approved for registration as FDIS
Plastics — Determination of matter extractable by organic solvents (conventional methods)
40.60 Close of voting
Plastics — Determination of dynamic mechanical properties — Part 10: Complex shear viscosity using a parallel-plate and a cone-and-plate oscillatory rheometer
40.60 Close of voting
Plastics — Methods of exposure to solar radiation — Part 1: General guidance
40.00 DIS registered
Plastics — Determination of creep behaviour — Part 2: Flexural creep by three-point loading
40.60 Close of voting
Plastics — Determination of burning behaviour of thin flexible vertical specimens in contact with a small-flame ignition source
40.60 Close of voting
Plastics — Test method of exposure to white LED lamps
50.00 Final text received or FDIS registered for formal approval
Plastics — Determination of fracture toughness of polyethylene (PE) under plane stress impact conditions
00.99 Approval to ballot proposal for new project
Plastics — Standard table for reference global solar spectral irradiance at sea level — Horizontal, relative air mass 1
60.60 Standard published
Plastics — Parameters comparing the spectral irradiance of a laboratory light source for weathering applications to a reference solar spectral irradiance
90.20 Standard under periodical review
Plastics — Use of polyethylene reference specimens (PERS) for monitoring laboratory and outdoor weathering conditions
90.92 Standard to be revised
Plastics — Guidance on fire characteristics and fire performance of PVC materials used in building applications
60.60 Standard published
Plastics — Environmental aspects — State of knowledge and methodologies
60.60 Standard published
Plastics — Determination of thermal conductivity and thermal diffusivity — Part 5: Results of interlaboratory testing of poly(methyl methacrylate) samples
60.60 Standard published
Plastics — Recycling and recovery — Necessity of standards
60.60 Standard published
Plastics — Development and use of intermediate-scale fire tests for plastics products — Part 2: Use of intermediate-scale tests for semi-finished and finished products
60.60 Standard published
Plastics — Method of controlled acceleration of laboratory weathering by increased irradiance
90.93 Standard confirmed
