EN 14385:2004 specifies a manual reference method for the determination of the mass concentration of specific elements in exhaust gases from harzardous and municipal waste incinerators. The method is applicable to each of the specific elements in the concentration range of 0,005 mg/m³ to 0,5 mg/m³. Unless otherwise stated, concentrations are expressed at volumes under dry conditions, normalised to 273 K, 101,3 kPa, and oxygen content with a volume fraction of 11 %. Specific elements according to this European Standard are antimony (Sb), arsenic (As), cadmium (Cd), chromium (Cr), cobalt (Co), copper (Cu), lead (Pb), manganese (Mn), nickel (Ni), thallium (Tl), and vanadium (V). This European Standard is also applicable to exhaust gases from other sources with a flue gas composition, similar to that given in Table 1. The performance characteristics of the method determined for waste incincerators cannot be extrapolated to be used for other types of matrix without any further validation work. NOTE: This European Standard has been validated with the described materials, equipment, sampling and digestion performances etc., followed by analyses with AAS and ICP. This does not exclude the use of other types that meet the requirements and proven to be equivalent to the described European Standard. This European Standard has been validated for the determination of the mass concentration of metals in incineration exhaust gases, within the uncertainties stated in Clause 9. If mercury is to be determined as well, this may be sampled in a side stream arrangement of the sampling train (EN 13211). EN 14385:2004 requires revision to bring up to date with EN 15259:2007.
Legislation related to this standard
WITHDRAWN
EN 14385:2004
ABANDON
prEN 14385 rev
00.98
Proposal for new project abandoned
Aug 7, 2017
