ISO/TS 17892-6:2004

Geotechnical investigation and testing — Laboratory testing of soil — Part 6: Fall cone test ISO/TS 17892-6:2004

Publication date:   Oct 21, 2004

95.99 Withdrawal of Standard   Mar 3, 2017

General information

95.99 Withdrawal of Standard   Mar 3, 2017

ISO

ISO/TC 182 Geotechnics

Technical Specification

93.020   Earthworks. Excavations. Foundation construction. Underground works | 13.080.20   Physical properties of soils

Buying

Withdrawn

Language in which you want to receive the document.

Scope

ISO/TS 17892-6:2004 specifies the laboratory determination of undrained shear strength of both undisturbed and remoulded specimen of saturated fine grained cohesive soils by use of a fall-cone.
This document specifies the fall-cone test, in which a cone is allowed to fall with its tip towards a soil specimen, whereupon the penetration of the cone into the soil is measured. Tests performed according to this test yield penetration values which can be used to estimate the undrained shear strength.
The test is applicable to both undisturbed and remoulded soil test specimen.
For undisturbed soil test specimen, the results of the test are dependent on the quality of the specimen. Because of possible effects of anisotropy, it can also differ depending on what undrained shear strength the relation refers to.
The evaluated value of the undrained shear strength of the 'undisturbed' soil refers to its state during the test in the laboratory. This value is not necessarily indicative of the undrained shear strength of the soil in its natural state in the field. Therefore, the test should be regarded as an index test.
NOTE 1 For non-homogeneous soil samples, this method yields values of the undrained shear strength which are less representative for the bulk shear strength of the sample than other tests involving a larger volume of soil.
NOTE 2 For disturbed soil samples and fissured soil samples this method normally yields higher strength values than tests involving a larger volume of soil.

Life cycle

NOW

WITHDRAWN
ISO/TS 17892-6:2004
95.99 Withdrawal of Standard
Mar 3, 2017

CORRIGENDA / AMENDMENTS

WITHDRAWN
ISO/TS 17892-6:2004/Cor 1:2006

REVISED BY

PUBLISHED
ISO 17892-6:2017