ISO 8178-1:2017

Reciprocating internal combustion engines — Exhaust emission measurement — Part 1: Test-bed measurement systems of gaseous and particulate emissions

Publication date:   Apr 20, 2017

95.99 Withdrawal of Standard   Jun 24, 2020

General information

95.99 Withdrawal of Standard   Jun 24, 2020

ISO

ISO/TC 70/SC 8 Exhaust gas emission measurement

International Standard

13.040.50   Transport exhaust emissions | 27.020   Internal combustion engines

Buying

  Withdrawn

PDF - €76.23

  English  



Buy

Scope

ISO 8178-1:2017 specifies the measurement methods for gaseous and particulate exhaust emissions from reciprocating internal combustion (RIC) engines on a test bed, necessary for determining one weighted value for each exhaust gas pollutant. Various combinations of engine load and speed reflect different engine applications (see ISO 8178‑4).
ISO 8178-1:2017 is applicable to RIC engines for mobile, transportable and stationary use, excluding engines for motor vehicles primarily designed for road use. This document can be applied to engines used, for example, for earth-moving machines, generating sets and for other applications.
In limited instances, the engine can be tested on the test bed in accordance with ISO 8178‑2, to test in field conditions. This can only occur with the agreement of the parties involved. It should be recognized that data obtained under these circumstances may not agree completely with previous or future data obtained under the auspices of this document.
For engines used in machinery covered by additional requirements (e.g. occupational health and safety regulations, regulations for power plants), additional test conditions and special evaluation methods may apply.
Where it is not possible to use a test bed or where information is required on the actual emissions produced by an in-service engine, the site test procedures and calculation methods specified in ISO 8178‑2 are appropriate.

Life cycle

PREVIOUSLY

WITHDRAWN
ISO 8178-1:2006

NOW

WITHDRAWN
ISO 8178-1:2017
95.99 Withdrawal of Standard
Jun 24, 2020

CORRIGENDA / AMENDMENTS

ABANDON
ISO 8178-1:2017/DAmd 1

REVISED BY

PUBLISHED
ISO 8178-1:2020