60.60 Standard published Oct 3, 2024
ISO
ISO/TC 29/SC 9 Tools with defined cutting edges, holding tools, cutting items, adaptive items and interfaces
International Standard
25.060.20 Dividing and tool-workpiece holding devices
This document specifies the dimensions of couplings for driven tool holders with polygonal taper shanks with flat contact surface (PTI). These shanks are the tool-side part of the interface to the (in cutting process non-rotating) tool carrier of machine tools (e.g. turret lathes, turning centres).
This document specifies a coupling type that applies to two of the three tool-side interface types defined in ISO 5686-1 (F, A). The tool shanks themselves are designed identically for all types.
— Shank type F has two holes for the coolant supply (F = fluid) on the face contact for use in two installation positions (offset by 180°).
— Shank type A has two holes on the face contact for the primary coolant supply and additional two holes for supplying the tool holder (driven tool) with sealing air (A = air). An installation position offset by 180° is possible. A spring-type straight pin belongs to the holder and avoids incorrect insertion.
PUBLISHED
ISO 5686-3:2024
60.60
Standard published
Oct 3, 2024