ISO 4359:2022

Flow measurement structures — Rectangular, trapezoidal and U-shaped flumes

Publication date:   Dec 19, 2022

General information

60.60 Standard published   Dec 19, 2022

ISO

ISO/TC 113/SC 2 Flow measurement structures

International Standard

17.120.20   Flow in open channels

Buying

  Published

PDF - €234.74

  English   French  



Buy

Scope

This document specifies methods for the measurement of flow in rivers and artificial channels under steady or slowly varying flow conditions, using certain types of critical-depth flumes (also known as “standing-wave flumes”). A wide variety of flumes has been developed, but only those critical-depth flumes which have received general acceptance after adequate research and field testing, and which therefore do not require in situ calibration, are considered herein.
The flow conditions considered are uniquely dependent on the upstream head, i.e. subcritical flow must exist upstream of the flume, after which the flow accelerates through the contraction and passes through its critical depth (see Figure 1). The water level downstream of the structure is low enough to have no influence upon its performance.
This document is applicable to three commonly used types of flumes, covering a wide range of applications, namely rectangular-throated, trapezoidal-throated and U-throated. The hydraulic theory behind this document was presented in Reference [7].
This document is not applicable to a form of flume referred to in the literature (sometimes called a “Venturi” flume) in which the flow remains subcritical throughout.
NOTE      The Venturi form of flume is based on the same principle as a Venturi meter used within a closed conduit system and relies upon gauging the head at two locations and the application of Bernoulli’s energy formula.

Life cycle

PREVIOUSLY

WITHDRAWN
ISO 4359:2013

WITHDRAWN
ISO 4359:2013/Amd 1:2017

NOW

PUBLISHED
ISO 4359:2022
60.60 Standard published
Dec 19, 2022