ISO 11738:2021

Agricultural irrigation equipment — Control heads

Publication date:   Oct 27, 2021

General information

60.60 Standard published   Oct 27, 2021

ISO

ISO/TC 23/SC 18 Irrigation and drainage equipment and systems

International Standard

65.060.35   Irrigation and drainage equipment

Buying

  Published

PDF - €116.16

  English  



Buy

Scope

This document specifies requirements for the components and method of installation of pressurized irrigation system control heads, referred to hereinafter as irrigation control heads, with a nominal size of up to and including 200 mm (nominal size of an irrigation control head or nominal size of a component).
This document is applicable only to the above-ground components of irrigation control heads for sprinkler irrigation and micro-irrigation (mini-sprinklers, drip irrigation, etc.). It is applicable to the basic irrigation control head, on which other irrigation control and command components (electrical, electronic and hydraulic) can be assembled, but does not deal with these additional components.
This document is not applicable to systems and/or components that can be required to prevent the water from freezing in the irrigation control head, such as dry-barrel hydrants or other types of hydrants.
This document does not specify construction or operating requirements for the individual components that make up the irrigation control head. These requirements are specified in the relevant standards for each component.

Life cycle

PREVIOUSLY

WITHDRAWN
ISO 11738:2000

NOW

PUBLISHED
ISO 11738:2021
60.60 Standard published
Oct 27, 2021