ISO 10605:2008

Road vehicles — Test methods for electrical disturbances from electrostatic discharge

Publication date:   Jul 7, 2008

95.99 Withdrawal of Standard   Jun 2, 2023

General information

95.99 Withdrawal of Standard   Jun 2, 2023

ISO

ISO/TC 22/SC 32 Electrical and electronic components and general system aspects

International Standard

43.040.10   Electrical and electronic equipment

Buying

  Withdrawn

PDF - €76.23

  English   French  



Buy

Scope

ISO 10605:2008 specifies the electrostatic discharge (ESD) test methods necessary to evaluate electronic modules intended for vehicle use. It applies to discharges in the following cases:

ESD in assembly;
ESD caused by service staff;
ESD caused by occupants.

ESD applied to the device under test (DUT) can directly influence the DUT. ESD applied to neighbouring parts can couple into supply and signal lines of the DUT in the vehicle and/or directly into the DUT.
ISO 10605:2008 describes test procedures for evaluating both electronic modules on the bench and complete vehicles. It also describes a test procedure that classifies the ESD sensitivity of modules for packaging and handling. ISO 10605:2008 applies to all types of road vehicles regardless of the propulsion system (e.g. spark-ignition engine, diesel engine, electric motor).
ISO 10605:2008 is based in part on IEC 61000-4-2 and describes vehicle-specific requirements.
ISO 10605:2008 does not apply to pyrotechnic modules.

Life cycle

PREVIOUSLY

WITHDRAWN
ISO 10605:2001

NOW

WITHDRAWN
ISO 10605:2008
95.99 Withdrawal of Standard
Jun 2, 2023

CORRIGENDA / AMENDMENTS

WITHDRAWN
ISO 10605:2008/Cor 1:2010

WITHDRAWN
ISO 10605:2008/Amd 1:2014

REVISED BY

PUBLISHED
ISO 10605:2023