90.93 Standard confirmed Jun 28, 2024
ISO
ISO/TC 184/SC 4 Industrial data
International Standard
25.040.40 Industrial process measurement and control
This part of ISO 10303 specifies the interpretation of the integrated resources to satisfy requirements for the
representation of the product shape using three-dimensional wireframe models that are bounded by a set of
connected edge sets.
The following are within the scope of this part of ISO 10303:
— the representation of wireframe models that are described by a graph of edges and vertices where the
edges intersect only at their vertices;
— the representation of a wireframe model by one or more connected edge sets that shall not overlap or
intersect except at their vertices or edges;
— points defined in a three-dimensional coordinate space;
— curves, including b-splines, defined in a three-dimensional coordinate space;
— the representation of a single wireframe model or an assembly of wireframe models.
The following are outside the scope of this part of ISO 10303:
— geometry defined in a two-dimensional coordinate space;
— surface geometry;
— solid geometry;
— shell topology.
PUBLISHED
ISO 10303-501:2000
90.93
Standard confirmed
Jun 28, 2024