EN ISO/ASTM 52903-1:2021

Additive manufacturing - Material extrusion-based additive manufacturing of plastic materials - Part 1: Feedstock materials (ISO/ASTM 52903-1:2020)

Publication date:   Jul 15, 2021

General information

60.60 Standard published   Mar 10, 2021

CEN

CEN/TC 438 Additive Manufacturing

European Norm

25.030   Additive manufacturing

Buying

  Published

PDF - €23.81

  English  



Buy

Scope

This document describes a method for defining requirements for plastic materials used in extrusion-based additive manufacturing (AM) processes. Materials include unfilled, filled, and reinforced plastic materials suitable for processing into parts. These materials can also contain special additives (e.g. flame retardants, stabilizers, etc.). Processes include all material extrusion-based AM processes.
This document is intended for use by manufacturers of materials, feedstocks, plastic parts or any combination of the three using material extrusion-based AM.
NOTE In some cases, material manufacturers can also be feedstock manufacturers. In other cases, a material manufacturer can supply materials (example: pellets) to a feedstock manufacturer (example: converter of pellets into filaments).
This document does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Life cycle

NOW

PUBLISHED
EN ISO/ASTM 52903-1:2021
60.60 Standard published
Mar 10, 2021

Relations

Adopted from ISO/ASTM 52903-1:2020 IDENTICAL