EN ISO 8249:2018

Welding - Determination of Ferrite Number (FN) in austenitic and duplex ferritic-austenitic Cr-Ni stainless steel weld metals (ISO 8249:2018)

Publication date:   Dec 17, 2018

General information

60.60 Standard published   Sep 19, 2018

CEN

CEN/TC 121 Welding and allied processes

European Norm

25.160.40   Welded joints and welds

Buying

  Published

PDF - €50.63

  English  



Buy

Scope

This document specifies the method and apparatus for:
— the measurement of the delta ferrite content, expressed as Ferrite Number (FN), in largely austenitic and duplex ferritic-austenitic stainless steel[1] weld metal through the attractive force between a weld metal sample and a standard permanent magnet;
— the preparation and measurement of standard pads for manual metal arc covered electrodes. The general method is also recommended for the ferrite measurement of production welds and for weld metal from other processes, such as gas tungsten arc welding, gas shielded metal arc welding and submerged arc welding (in these cases, the way of producing the pad should be defined);
— the calibration of other instruments to measure FN.
The method laid down in this document is intended for use on weld metals in the as-welded state and on weld metals after thermal treatments causing complete or partial transformation of ferrite to any non-magnetic phase. Austenitizing thermal treatments which alter the size and shape of the ferrite change the magnetic response of the ferrite.
The method is not intended for measurement of the ferrite content of cast, forged or wrought austenitic or duplex ferritic-austenitic steel samples.

[1] The term "austenitic-ferritic (duplex) stainless steel" is sometimes applied in place of "duplex ferritic-austenitic stainless steel".

Life cycle

PREVIOUSLY

WITHDRAWN
EN ISO 8249:2000

NOW

PUBLISHED
EN ISO 8249:2018
60.60 Standard published
Sep 19, 2018