The whole document deals with insulation coordination in railways. It applies to equipment for use in signalling, rolling stock and fixed installations up to 2000 m above sea level.
Insulation coordination is concerned with the selection, dimensioning and correlation of insulation both within and between items of equipment. In dimensioning insulation, electrical stresses and environmental conditions are taken into account. For the same conditions and stresses these dimensions are the same.
OneAn objective of insulation coordination is to avoid unnecessary overdimensioning of insulation.
This standard specifies:
requirements for clearances and creepage distances for equipment;
general requirements for tests pertaining to insulation coordination.
The term equipment relates to a section as defined in 1.3.1.3: it may apply to a system, a sub-system, an apparatus, a part of an apparatus, or a physical realisation of an equipotential line.
This standard does not deal with :
distances through solid or liquid insulation;
distances through gases other than air;
distances through air not at atmospheric pressure;
equipment used under extreme conditions.
Product standards have to align with this generic standard.
However, they may require, with justification, different requirements due to safety and/or reliability reasons, e.g. for signalling, and/or particular operating conditions of the equipment itself, e. g. overhead lines which have to comply to EN 50119.
This standard also gives provisions for dielectric tests (type tests or routine tests) on equipment (see annex B).
NOTE For safety critical systems, specific requirements are needed. These requirements will be resolved in the product specific signalling standard EN 50129 (in preparation).
Legislation related to this standard
Interoperability of the trans-European high-speed rail system
Harmonized/SupportingDIRECTIVE 2008/57/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 17 June 2008 on the interoperability of the rail system within the Community (Recast)
Harmonized/Supporting
WITHDRAWN
EN 50124-1:2001
99.60
Withdrawal effective
Feb 6, 2020
WITHDRAWN
EN 50124-1:2001/A2:2005
WITHDRAWN
EN 50124-1:2001/A1:2003
WITHDRAWN
EN 50124-1:2001/corrigendum May 2010
WITHDRAWN
EN 50124-1:2001/corrigendum Dec. 2007
PUBLISHED
EN 50124-1:2017