EN 1109:2013

Flexible sheets for waterproofing - Bitumen sheets for roof waterproofing - Determination of flexibility at low temperature

Publication date:   Jul 15, 2013

General information

90.93 Standard confirmed   Feb 19, 2020

CEN

CEN/TC 254 Flexible sheets for waterproofing

European Norm

91.100.50   Binders. Sealing materials

Buying

  Published

PDF - €17.84

  Bulgarian   English  



Buy

Scope

This European Standard specifies the determination of flexibility of bitumen sheets at low temperatures. The test can be carried out on the upper or lower face of the sheet either at a predetermined temperature or successively at different temperature steps to determine the cold bending temperature which represents a limiting temperature. Therefore, the test can be used to confirm a minimum cold bending temperature for a product or to determine the specific cold bending temperature for the product e.g. to determine the change of these properties as a result of artificial ageing.
In the case of sheets with the same bituminous compound on both sides and where the reinforcement is placed in the cross section visually closer to the upper surface, the test is performed on the bottom face only.
If the upper surface is covered with a non woven (e.g. tissue, fleece etc.) or metal facing, the test is performed on the bottom side only.
If the sheet on the upper surface is covered with permanent light surface protection and where the reinforcement is placed in the cross section visually closer to the upper surface, the test is performed on the bottom side only.

Life cycle

PREVIOUSLY

WITHDRAWN
EN 1109:1999

NOW

PUBLISHED
EN 1109:2013
90.93 Standard confirmed
Feb 19, 2020