CEN/TS 16675:2014

Characterisation of waste - Test methods for the determination of the monolithic status of waste

Publication date:   Dec 17, 2014

General information

99.60 Withdrawal effective   Aug 22, 2018

CEN

CEN/TC 444 Environmental characterization of solid matrices

Technical Specification

13.030.10   Solid wastes

Buying

  Withdrawn

PDF - €20.78

  English  



Buy

Scope

This Technical Specification provides methods, which can be used to assess the monolithic character of a stabilised/solidified waste, with respect to landfilling. Information on the monolithic character is required to enable the choice of appropriate leaching tests for determination of the release of different substances from stabilised/solidified waste under specified (landfilling) conditions.
This document includes several physical and/or chemical test methods each addressing different aspects of monolithic character. The selection of methods required for an assessment of the monolithic character of a stabilised/solidified waste may vary, depending on the scenario to be addressed or it may be specified in regulation.
Rather than describing the procedures and methods in detail this document refers to existing standards and provides some guidance on their use on stabilised/solidified waste materials.
This Technical Specification does not address issues related to health and safety.
The following procedures and methods are included in this document:
- test to determine unconfined compressive strength;
- test to determine permeability;
- test to determine the loss of mass by dissolution or disintegration;
- test to determine expansion;
- test to determine the content of organic matter;
- test to determine freeze/thaw effects.

Life cycle

NOW

WITHDRAWN
CEN/TS 16675:2014
99.60 Withdrawal effective
Aug 22, 2018

REVISED BY

PUBLISHED
CEN/TS 16675:2018