99.60 Withdrawal effective Dec 11, 2013
CEN
CEN/TC 155 Plastics piping systems and ducting systems
Technical Specification
23.040.01 Pipeline components and pipelines in general | 91.140.60 Water supply systems | 91.140.80 Drainage systems | 93.030 External sewage systems
This Technical Specification (CEN/TS) specifies recommended practices for installing piping systems made of glass-reinforced thermosetting plastics based on unsaturated polyester resin (GRP-UP), intended to be used for pressure or non-pressure water or sewerage applications. It is applicable to GRP-UP piping systems of nominal sizes from DN 100 to DN 3000 which are intended to be used for the conveyance of liquids at temperatures up to 50 °C and at pressures of 0,5 bar and greater.
NOTE 1 Piping systems conforming to prEN 1796 [4] or prEN 14364 [5] can also be used for above-ground applications provided the influence of the environment and the supports is considered in the design of the pipes and joints.
NOTE 2 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.
Legislation related to this standard
Regulation (eu) No 305/2011 of the European Parliament and of the Council of 9 march 2011 laying down harmonised conditions for the marketing of construction products and repealing council directive 89/106/eec
WITHDRAWN
EN 1636-6:1997
WITHDRAWN
CEN/TS 14578:2003
99.60
Withdrawal effective
Dec 11, 2013
PUBLISHED
CEN/TS 14578:2013