Main menu
Draft
This part of IEC 61730 specifies and describes the fundamental construction requirements for photovoltaic (PV) modules in order to provide safe electrical and mechanical operation. Specific topics are provided to assess the prevention of electrical shock, fire hazards, and personal injury due to mechanical and environmental stresses. This part of IEC 61730 pertains to the particular requirements of construction. IEC 61730-2 defines the requirements for testing. Modules with modified construction shall be qualified as described in IEC TS 62915.
This document lays down requirements for terrestrial PV modules suitable for long-term operation in open-air climates with 98th percentile operating temperatures of 70 °C or less. Recommendations for modules to be used at higher operating temperatures are described in IEC TS 63126. The useful service life of modules so qualified will depend on their design, their environment and the conditions under which they are operated. Therefore, test results should not be construed as a quantitative prediction of module lifetime.
This document is intended to apply to all terrestrial flat plate module materials, such as crystalline silicon module types as well as thin-film modules. PV modules covered by this document are limited to a maximum DC system voltage of 1 500 V.
This International Standard defines the basic requirements for various applications of PV modules, but it cannot be considered to encompass all national or regional codes. Specific requirements, e.g. for building, marine and vehicle applications, are not covered.
This International Standard does not address specific requirements for products that combine a PV module with power conversion equipment, monitoring or control electronics, such as integrated inverters, converters or output disabling functions.
While parts of this document may be applicable to flat plate PV modules with internally generated low-level concentration below 3 times, it was not written specifically to address these concerns.
This International Standard is designed to coordinate with the test sequences in the IEC 61215 series, so that a single set of samples may be used to perform both the safety and qualification of a PV module design.
Additional construction requirements outlined in relevant ISO standards, or the national or local codes which govern the installation and use of these PV modules in their intended locations, should be considered in addition to the requirements contained within this document.
Legislation related to this standard
Directive 2014/35/EU of the European Parliament and of the Council of 26 February 2014 on the harmonisation of the laws of the Member States relating to the making available on the market of electrical equipment designed for use within certain voltage limits
IN_DEVELOPMENT
FprEN IEC 61730-1:2023
50.60
Close of voting. Proof returned by secretariat
May 19, 2023