EN ISO 1133:2005

Plastics - Determination of the melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of thermoplastics (ISO 1133:2005) EN ISO 1133:2005

Publication date:   Aug 10, 2006

General information

99.60 Withdrawal effective   Dec 1, 2011

CEN

CEN/TC 249 Plastics

European Norm

83.080.20   Thermoplastic materials

Buying

Withdrawn

Language in which you want to receive the document.

Scope

ISO 1133:2005 specifies two procedures for the determination of the melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of thermoplastic materials under specified conditions of temperature and load. One is a mass-measurement method. The other is a displacement-measurement method. Normally, the test conditions for measurement of melt flow rate are specified in the material standard with a reference to ISO 1133. The test conditions normally used for thermoplastics are listed in annexes.
These methods are in principle also applicable to thermoplastics for which the rheological behaviour is affected during the measurement by phenomena such as hydrolysis, condensation or crosslinking, but only if the effect is limited in extent and only if the repeatability and reproducibility are within an acceptable range. For materials which show significantly affected rheological behaviour during testing, these methods are not appropriate. In such cases, the use of the viscosity number in dilute solution, determined in accordance with the relevant part of ISO 1628, is recommended for characterization purposes.

Life cycle

PREVIOUSLY

WITHDRAWN
EN ISO 1133:1999

NOW

WITHDRAWN
EN ISO 1133:2005
99.60 Withdrawal effective
Dec 1, 2011

CORRIGENDA / AMENDMENTS

WITHDRAWN
EN ISO 1133:2005/AC:2006

REVISED BY

WITHDRAWN
EN ISO 1133-1:2011

PUBLISHED
EN ISO 1133-2:2011