EN 60695-2-10:2013

Fire hazard testing - Part 2-10: Glowing/hot-wire based test methods - Glow-wire apparatus and common test procedure

Publication date:   Aug 15, 2013

General information

60.60 Standard published   Jun 28, 2013

CENELEC

CLC/SR 89 Fire hazard testing

European Norm

13.220.40   Ignitability and burning behaviour of materials and products | 29.020   Electrical engineering in general

Buying

  Published

PDF - €40.11

  English  



Buy

Scope

IEC 60695-2-10:2013 specifies the glow-wire apparatus and common test procedure to simulate the effects of thermal stresses which may be produced by heat sources such as glowing elements or overloaded resistors, for short periods, in order to assess the fire hazard by a simulation technique. The test procedure described in this standard is a common test procedure intended for the small-scale tests in which a standardized electrically heated wire is used as a source of ignition. It is a common part of the test procedures applied to end products and to solid electrical insulating materials or other solid combustible materials. A detailed description of each particular test procedure is given in the respective standards IEC 60695-2-11, IEC 60695-2-12 and IEC 60695-2-13. This second edition of IEC 60695-2-10 cancels and replaces the first edition of IEC 60695-2-10 published in 2000. This edition constitutes a technical revision. The main changes with respect to the previous edition are as follows: - A table of contents has been added. - The introduction has been updated to align with other TC89 documents. - The scope has been clarified to align with other documents in the IEC 60695-2 Glow-wire series. - Terms and definitions relevant to this document have been added. - Clause 4 has been deleted and the remaining clauses renumbered. - The description of the power supply has been updated with additional details (see 4.1). - The temperature measuring system (see 4.3) and the description of the specified layer has been updated (see 4.4). - New guidance has been introduced to assist in the verification of the temperature measuring system (see 5.2 and Annex C). - The common test produced has been clarified (see Clause 7). - The tolerances have been changed for the dimensions of the glow-wire (see Figure 1). - New guidance on flaming observations has been added (see Annex B). It has the status of a basic safety publication in accordance with IEC Guide 104 and ISO/IEC Guide 51. This standard is to be used in conjunction with IEC 60695-2-11, IEC 60695-2-12, and IEC 60695-2-13. Keywords: Glowing/hot-wire, Glow-wire.

Related legislation

Legislation related to this standard

2014/35/EU

Directive 2014/35/EU of the European Parliament and of the Council of 26 February 2014 on the harmonisation of the laws of the Member States relating to the making available on the market of electrical equipment designed for use within certain voltage limits

Harmonized/Supporting

Life cycle

PREVIOUSLY

WITHDRAWN
EN 60695-2-10:2001

NOW

PUBLISHED
EN 60695-2-10:2013
60.60 Standard published
Jun 28, 2013

REVISED BY

PUBLISHED
EN IEC 60695-2-10:2021