Projects

Use the form below to find particular standards or projects. Enter your criteria for searching (single or in combination) in the fields below and press the button “Search”. You can also search using the Advance Search facility.

Health services - Quality management systems - Guide for the use of EN ISO 9004:2000 in health services for performance improvement

60.60 Standard published

CEN/TC 362

Materials obtained from End-of-Life Tyres - Granulated rubber - Determination of textile fiber content by visual index (qualitative method)

60.60 Standard published

CEN/TC 366

Materials obtained from End-of-Life Tyres - Odour of ELT granulates - Origin and remediation possibilities

60.60 Standard published

CEN/TC 366

Biomass gasification - Tar and particles in product gases - Sampling and analysis

90.93 Standard confirmed

CEN/TC 363

Internet Content and communications filtering software and services

90.93 Standard confirmed

CEN/TC 365

Materials obtained from End of Life Tyres - Determination of specific requirements for sampling and determination of moisture content using the oven-dry method

90.93 Standard confirmed

CEN/TC 366

Materials obtained from end-of-life tyres - Quality criteria for the selection of whole tyres, for recovery and recycling processes

60.60 Standard published

CEN/TC 366

Materials obtained from end of life tyres (ELT) - Sampling method for granulates and powders stored in big-bags

60.60 Standard published

CEN/TC 366

Materials obtained from end of life tyres (ELT) - Determination of the true density of granulates - Method based on water pycnometry

60.60 Standard published

CEN/TC 366

Material derived from End-of-Life tyres - Granulates and powders - Elastomers identification: Gas-chromatography and mass-spectrometric detection of pyrolysis products in solution

90.60 Close of review

CEN/TC 366

Materials produced from end of life tyres - Steel wire - Determination of the non-metallic content

60.60 Standard published

CEN/TC 366

Materials obtained from end-of-life tyres - Determination of the specific surface area of powders - Method based on krypton adsorption

60.60 Standard published

CEN/TC 366

Capacitance graded outdoor bushing 52 kV up to 420 kV for oil immersed transformers

60.60 Standard published

CLC/TC 36A

Materials obtained from end of life tyres - Part 1: General definitions related to the methods for determining their dimension(s) and impurities

60.60 Standard published

CEN/TC 366

Materials obtained from end of life tyres - Part 2: Granulates and powders - Methods for determining the particle size distribution and impurities, including free steel and free textile content

60.60 Standard published

CEN/TC 366

Materials obtained from end of life tyres - Part 3: Shreds, cuts and chips - Methods for determining their dimension(s) including protruding filaments dimensions

60.60 Standard published

CEN/TC 366

Organic coating systems and linings for protection of industrial apparatus and plants against corrosion caused by aggressive media - Part 1: Terminology, design and preparation of substrate

90.60 Close of review

CEN/TC 360

Organic coating systems and linings for protection of industrial apparatus and plants against corrosion caused by aggressive media - Part 2: Coatings on metallic components

90.60 Close of review

CEN/TC 360