CEN Guide 414:2004

Safety of machinery - Rules for the drafting and presentation of safety standards CEN Guide 414:2004

General information

99.60 Withdrawal effective   Apr 2, 2014

CEN

CEN/BT

Guide

Scope

This document specifies requirements for the drafting and presentation of European machinery safety standards and standards for safety components, primarily to achieve consistency and acceptable quality, throughout the programme, of the various standards to be prepared (also to meet the requirements of the Mandates from the European Commission).
It also gives requirements on the criteria for the selection of new work items and for procedures to prepare, produce or revise standards in an efficient and effective way.
This document gives requirements which are additional to the CEN/CENELEC Internal Regulations - Part 3 (based on ISO/IEC Directives, Part 2) when this is necessary because of the special requirements of machinery safety standards and standards for safety components.
This document is primarily intended for the drafting of type C standards. It also applies to type B standards but the foreseeable variation in the format of these standards prevents general application. When requirements specifically apply to type B standards, this is indicated.

Life cycle

NOW

WITHDRAWN
CEN Guide 414:2004
99.60 Withdrawal effective
Apr 2, 2014

REVISED BY

WITHDRAWN
CEN Guide 414:2014

Relations

Adopted from ISO Guide 78:2008 MODIFIED