EN 12201-5:2011

Plastics piping systems for water supply, and for drainage and sewerage under pressure - Polyethylene (PE) - Part 5: Fitness for purpose of the system EN 12201-5:2011

Publication date:   Nov 17, 2011

General information

99.60 Withdrawal effective   Jan 31, 2024

CEN

CEN/TC 155 Plastics piping systems and ducting systems

European Norm

23.040.05   Pipelines and its parts for external sewage systems

Buying

Withdrawn

Language in which you want to receive the document.

Scope

This European Standard specifies the characteristics of the fitness for purpose of the assembled piping systems
intended for the conveyance of water intended for human consumption, raw water prior to treatment, drainage and
sewerage under pressure, vacuum sewer systems, and water for other purposes.
It also specifies the method of preparation of test piece joints, and the tests to be carried out on these joints for
assessing the fitness for purpose of the system under normal and extreme conditions.
NOTE 1 For PE components intended for the conveyance of water for human consumption and raw water prior to treatment
attention is drawn to the introduction of this part of EN 12201. Components manufactured for water for other purposes may not
be suitable for water supply for human consumption.
It also specifies the test parameters for the test methods referred to in this standard.
In conjunction with Parts 1 to 4 of EN 12201 it is applicable to PE pipes, fittings, valves, their joints and to joints
with components of other materials intended to be used under the following conditions:
a) allowable operating pressure, PFA, up to 25 bar 1) ;
b) an operating temperature of 20 °C as a reference temperature.
c) buried in the ground;
d) sea outfalls;
e) laid in water;
f) above ground, including pipes suspended below bridges.
NOTE 2 For applications operating at constant temperatures greater than 20 °C up to 40 °C, see Annex A of
EN 12201-1:2011.
EN 12201 (all parts) covers a range of allowable operating pressures and gives requirements concerning colours
and additives.
NOTE 3 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into
account their particular requirements and any relevant national guidance or regulations and installation practices or codes.

Related legislation

Legislation related to this standard

89/106/EEC

Construction products

305/2011

Regulation (eu) No 305/2011 of the European Parliament and of the Council of 9 march 2011 laying down harmonised conditions for the marketing of construction products and repealing council directive 89/106/eec

Life cycle

PREVIOUSLY

WITHDRAWN
EN 13244-5:2002

WITHDRAWN
EN 12201-5:2003

NOW

WITHDRAWN
EN 12201-5:2011
99.60 Withdrawal effective
Jan 31, 2024

REVISED BY

PUBLISHED
EN 12201-5:2024