Main menu
0
0

EN 1852-1:2009

Plastics piping systems for non-pressure underground drainage and sewerage - Polypropylene (PP) - Part 1: Specifications for pipes, fittings and the system

Oct 30, 2009

General information

99.60 Withdrawal effective   Jan 10, 2018

CEN

CEN/TC 155 Plastics piping systems and ducting systems

European Norm

23.040.01   Pipeline components and pipelines in general | 23.040.05   Pipelines and its parts for external sewage systems | 91.140.80   Drainage systems | 93.030   External sewage systems

Buying

Withdrawn

Preview

Language in which you want to receive the document.

Scope

This part of EN 1852 specifies the requirements for solid wall pipes, fittings and the system of polypropylene (PP) piping systems intended for use for:
 non-pressure underground drainage and sewerage outside the building structure (application area code "U"), and
 non-pressure underground drainage and sewerage for both buried in ground within the building structure (application area code "D") and outside the building structure.
This is reflected in the marking of products by "U" and "UD".
This standard covers PP materials without mineral modifiers.
It also specifies the test parameters for the test methods referred to in this standard.
This standard covers a range of nominal sizes, and pipe series and gives recommendations concerning colours.
NOTE 1 It is the responsibility of the purchaser or specifier to make the appropriate selection from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.
In conjunction with Part 2 and Part 3 of EN 1852 it is applicable to PP pipes and fittings, their joints and to joints with components of other plastics and non-plastics materials intended to be used for buried piping systems for non-pressure underground drainage and sewerage.
This standard is applicable to PP pipes and fittings with or without an integral socket.
NOTE 2 The fittings can be manufactured by injection-moulding or be fabricated from pipes and/or mouldings.
NOTE 3 Requirements and limiting values for application area code "D" are given in Table 3, Table 7 and Table 14.
NOTE 4 Pipes, fittings and other components conforming to any of the plastics product standards listed in Annex C can be connected to pipes and fittings conforming to this standard, when they conform to the requirements for joint dimensions given in Clause 6 and to the requirements of Table 14.

Related directives

Directives related to this standards.

89/106/EEC

Construction products

305/2011

Regulation (eu) No 305/2011 of the European Parliament and of the Council of 9 march 2011 laying down harmonised conditions for the marketing of construction products and repealing council directive 89/106/eec

Life cycle

PREVIOUSLY

Replaces
EN 1852-1:1997

Replaces
EN 1852-1:1997/A1:2002

NOW


EN 1852-1:2009
99.60 Withdrawal effective
Jan 10, 2018

REVISED BY

PUBLISHED
EN 1852-1:2018