EN ISO 899-1:2003

Plastics - Determination of creep behaviour - Part 1: Tensile creep (ISO 899-1:2003) EN ISO 899-1:2003

Publication date:   Mar 30, 2004

General information

99.60 Withdrawal effective   Nov 15, 2017

CEN

CEN/TC 249 Plastics

European Norm

83.080.01   Plastics in general

Buying

Withdrawn

Language in which you want to receive the document.

Scope

ISO 899-1:2003 specifies a method for determining the tensile creep of plastics in the form of standard test specimens under specified conditions such as those of pretreatment, temperature and humidity.
The method is suitable for use with rigid and semi-rigid non-reinforced, filled and fibre-reinforced plastics materials (see ISO 472 for definitions) in the form of dumb-bell-shaped test specimens moulded directly or machined from sheets or moulded articles.
The method is intended to provide data for engineering-design and research and development purposes. Data for engineering-design purposes requires the use of extensometers to measure the gauge length of the specimen. Data for research or quality-control purposes may use the change in distance between the grips (nominal extension).
Tensile creep may vary significantly with differences in specimen preparation and dimensions and in the test environment. The thermal history of the test specimen can also have profound effects on its creep behaviour. Consequently, when precise comparative results are required, these factors must be carefully controlled.
If tensile-creep properties are to be used for engineering-design purposes, the plastics materials should be tested over a broad range of stresses, times and environmental conditions.

Life cycle

PREVIOUSLY

WITHDRAWN
EN ISO 899-1:1996

NOW

WITHDRAWN
EN ISO 899-1:2003
99.60 Withdrawal effective
Nov 15, 2017

CORRIGENDA / AMENDMENTS

WITHDRAWN
EN ISO 899-1:2003/A1:2015

REVISED BY

PUBLISHED
EN ISO 899-1:2017